ximon
-
Posts
6 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by ximon
-
-
Strangely enough, it didn't work when I turned the firewall off, only when I allowed both .exes through. It may work with only curaengine.exe in the exceptions, as that's the one that's trying to open the port.
-
I had the same issue on two machines, i had to add curaengine.exe as well as cura.exe to the firewall exceptions before it would load.
-
Ever since updating to cura 4.0 stable I'm having difficulty selecting parts when zoomed out enough to get the whole bed on screen, weirdly if i use the right mouse button the part selects immediately and the context menu pops up as expected. If i zoom in so just the part fills the screen its easier to select.
Anybody else have this issue?
-
Ever since updating to cura 4.0 stable I'm having difficulty selecting parts when zoomed out, weirdly if i use the right mouse button the part selects immediately and the context menu pops up as expected. If i zoom in so the part fills the screen its easier to select.
Cura 4.4.0 stuck at starting
in UltiMaker Cura
Posted
I'm getting this with 4.4.1 too, takes a couple of rounds of run-kill before it will start properly