Starrfire
-
Posts
5 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Starrfire
-
-
Slicing "teeth_top" from here: https://www.thingiverse.com/thing:2736627/files using Cura 4.1
I'm trying to use brim to help them adhere to the plate and it fails to draw a brim for a few of the teeth. The same problem happens with support enabled/disabled, raft and skirt too.
-
Reprint worked very well!
-
I enabled "Print thin walls" and adaptive layers - in preview it's looking better now. I'm going to try printing it again.
-
Image 1: prepare
Image 2: preview
Question: why are the rose petals floating in mid-air in preview? Is this just too fine to print? And in Cura are there any settings I can use to correct it?
Note: I tried printing it (0.15mm normal quality) and the petals are a tangle of strands. Everything else looks perfect.
Setup: Ender 3 Pro running Cura 4.0
Original - printed at 50% of its scale:
Brim incorrectly added printing teeth
in UltiMaker Cura
Posted
Thanks! That seems quite possible - although shouldn't it build supports to them if they are not on the build plate?