Jump to content

visualplastik

Member
  • Content Count

    5
  • Joined

  • Last visited

Community Reputation

1 Neutral
  1. Try Optimize Wall Printing Order, it does several lines around holes all at once with leaving and returning.
  2. Sorry, had a few reversed normals. Solved.
  3. I don't have remove all holes checked. The normals are not reversed. Make overhang printable not checked. Same results in Cura 3 or 4. right-side-front.stl
  4. I just had the same problem coming from C4D. One of the intersecting objects had inverted normals. So the inside faces were outside. And when merged by the slicer it was making a hole where there was an intersection. In C4D the inside faces are blue when selected and the outside are yellow. If they're wrong select all the faces and run reverse normals. This fixed it right away.
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!