Jump to content

DTMLUND

New member
  • Content Count

    1
  • Joined

  • Last visited

Everything posted by DTMLUND

  1. Hi All So far I have been very satisfied with my Ultimaker S5. However, I do occasionally run into network issues, where the print can't be delivered over local network through Cura. The error message is that the print failed to be delivered after multiple attempts. This error message is only present in Cura Connect - when I send the print, Cura says that the printer has received it successfully, but the printer never starts. I have tried multiple resets without any luck. Do any of you guys experience the same problem? Also, I agree with some other posts that white text on grey buttons is terrible - especially if you view the display from an angle. Best regards
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!