UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
So far I have been very satisfied with my Ultimaker S5.
However, I do occasionally run into network issues, where the print can't be delivered over local network through Cura. The error message is that the print failed to be delivered after multiple attempts. This error message is only present in Cura Connect - when I send the print, Cura says that the printer has received it successfully, but the printer never starts. I have tried multiple resets without any luck. Do any of you guys experience the same problem?
Also, I agree with some other posts that white text on grey buttons is terrible - especially if you view the display from an angle.
Ultimaker S5 | impressions & opinions
in UltiMaker 3D printers
Posted
Hi All
So far I have been very satisfied with my Ultimaker S5.
However, I do occasionally run into network issues, where the print can't be delivered over local network through Cura. The error message is that the print failed to be delivered after multiple attempts. This error message is only present in Cura Connect - when I send the print, Cura says that the printer has received it successfully, but the printer never starts. I have tried multiple resets without any luck. Do any of you guys experience the same problem?
Also, I agree with some other posts that white text on grey buttons is terrible - especially if you view the display from an angle.
Best regards