Jump to content

bobster316

Member
  • Posts

    8
  • Joined

  • Last visited

Everything posted by bobster316

  1. Additionally when tryiung to add custom support I get the following
  2. I am relatively new to using cura and need some help for this issue. I am trying to slice a part which requirees support. If i generate regular support, there is too much support, I tried a custom support plugin from the marketplace but everytime I add custom support the object hets greyed out and i cannot tell where to adjust the support I am trying to add, Attached is the ender 3 v2 psu cover which I am trying to slice (the below example is for regular support being added everywhere,
  3. I have an obkect which I need to printm the shape has holes for 40mm fans and usb ports etc,, There are also 2.5mm holes on the inside of the shape whoch are needed for brass standoffs. I used cura tp generate supports, however when i print the shape, two of bottom 2.5mm are filled due to support. I Is there a way oof keeping the larger gaps filled with support and small holes without support? ThanksShape
  4. Hi I have been working on a project to develop a vase for raspberry pi 4. I have the gcode files and needed to make a change to the design. Unfortunately i cannot find the source STL file. IS it possible to bring the gcode file back into Cura and change it back to an STL file so it can be edited and converted back to an STL.
  5. I would like to add support filling in gaps/spaces in the attached shape 4 gaps at the front of the case, 1 gap at the rear and multiple holes at the top and bottom of the case Can anyone please reco,mmend the best solution
  6. I previously created a shape and then added support fills in all the gaps which could be removed afer printing. I cannot remember how i did it. Appreciate if someone can provide some guidance. Attached are images of the purple shape which had the gaps filled to provide a clean hole wen the extra in fill was removed. (grey shape)
  7. I am test printing a large Benchy from Ender 3 v2. Have noticed some stringing at the rear of the Benchy. The print is still being printed and will let it continue till it finished. Ender 3 v2 Stringing at Rear of Benchy Print Appreciate if anyone can advise what the issue might be. Thanks
  8. Associate Joined: Oct 6, 2018 Posts: 8 Location: Isleworth
×
×
  • Create New...