Jump to content

jamessalvant

Dormant
  • Posts

    1
  • Joined

  • Last visited

jamessalvant's Achievements

0

Reputation

  1. I have an Ultimaker 2+ that is now failing prints and adding time to prints. Current Setup Ultimaker 2+ current firmware 5.2 Cura 4.0- fresh reinstall with no modification to settings Material is Ultimaker PLA Model is loaded into Cura and sliced showing 3.5 hour print time Model is saved to SD card for printing SD card inserted and print starts with progress time showing 3.5 hours to complete Print starts off great.. then sometime about 1 hour mark it starts to add time for completion... currently now at 36 hours????? Print will eventually fail as if its skipping layers Anyone else had this happen???? Printer is a few years old with low use on it.. I have changed out the nozzle , updated the firmware, reinstalled cura ... still same problem... what should I do next Thanks in advance for your help! James
×
×
  • Create New...