Jump to content

chielsen

New member
  • Posts

    1
  • Joined

  • Last visited

chielsen's Achievements

0

Reputation

  1. Hello For a school project we're supposed to 3D-Print a real estate development. I've made the design in SketchUp and printed it a first time to test, the baseplate was a little thin and it wasn't the full model yet (to not waste to much time if something went wrong seeing as it's my first time printing). So now I've sliced the complete model and made the baseplate three times thicker, but now Cura adds support structures to almost every single building where as earlier it only did it where there was actual overhang. Print 1 (which was succesful) looked like this in Cura: https://imgur.com/HXKS6Rp Print 2 looks like this: https://imgur.com/DJP6PfE Why does this happen? Any help is greatly appreciated. Kind regards Rik
×
×
  • Create New...