Jump to content

TeckKonceptz

Member
  • Content Count

    3
  • Joined

  • Last visited

Community Reputation

1 Neutral
  1. Can you share some of your current prints with TL- smoothers installed ? Im on the fence about doing the Duet swap but Im a little hesitant as the the Z endstop is still a little bit of a concern.
  2. Whats the advantage of using Cura directly to Octoprint?
  3. I'm trying to resolve the same issue, in S3D there is a lift when traveling setting I'm trying to find a similar setting in Cura.
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!