Jump to content

Irigale

Dormant
  • Posts

    3
  • Joined

  • Last visited

Posts posted by Irigale

  1. 18 minutes ago, ultiarjan said:

    I don’t see the picture, but from what I understand your nozzle clogged and then the feeder is grinding the filament.

     

    I would advise to clean the nozzle (google: atomic pull or cold pull) and maybe also clean the feeder if it happens again.

     

    The main reasons for this issue is printing to fast and/or printing not hot enough. Try starting with Cura’s default profiles and you should be fine.

     

    Finally, do you have an Ultimaker2 (with the small black feeder) or an ultimaker2+ (white feeder) if its still the old black feeder I would advise to upgrade with a bondtech feeder.

    Thanks For your help Ultiarjan, 

    We have already clean the nozzle and the feeder, but it doesn't work. 

    I will try the second option. 

  2. Hello everybody, I'm a French student in Mechanical Engineering, I would like to ask you a question about the Ultimaker 2 of 3D Print. I did lot of test of Large part and I meet the same problem, which is the thickness. I want  to have a thickness of 15 mm but I get a thickness of 6mm. I don't understand why the 3D print continues its trajectory without extruding wire. I notices the wire don't go out of the nozzle, I notice also the groove on the outside of the engine remove a small part of the wire that's why the wire isn't extrude. 

    I would like to ask you if there is specific parameter to be set in the 3D print, or on the sleecer ( conversion software between the CAD and the 3D print) . 

    I  join you a picture to better understand the situation. 

    thumbnail?appId=YMailNorrin&downloadWhenThumbnailFails=true&pid=2

  3. Bonjour tout le monde, je suis un étudiant français en génie mécanique, j'aimerais vous poser une question à propos de l'Ultimaker 2 de 3D Print. J'ai fait beaucoup d'essais de grande pièce et je rencontre le même problème, qui est l'épaisseur. Je veux avoir une épaisseur de 15 mm mais je reçois une épaisseur de 6 mm. Je ne comprends pas pourquoi l’impression 3D continue sa trajectoire sans fil extrudé. Je remarque que le fil ne sort pas de la buse, je remarque également que la rainure à l'extérieur du moteur enlève une petite partie du fil, ce qui explique pourquoi le fil n'est pas extrudé. 

    Je voudrais vous demander si un paramètre spécifique doit être défini dans l'impression 3D ou sur le sleecer (logiciel de conversion entre la CAO et l'impression 3D). 

    Je vous joins une photo pour mieux comprendre la situation. 

    thumbnail? appId = YMailNorrin & downloadWhenThumbnailFails = true & pid = 2

×
×
  • Create New...