I'm using an Ender 3, and the filament is a new national filament (which is supposed to be printed with the same settings as PLA, because it's not a filament that much flexible). I will try oiling it, the settings I'm currently using are:
- temp: 220C
- speed: 50mm/s
- flow: 110%
- retraction enabled, 5mm @ 25mm/s
I know that these settings aren't for most flexible filaments, but as I'm telling you this is a "new" "experimental" filament type. Supposed to be just as easy to print as PLA (and so far, aside that inconvenience, the prints are flawless, I attach a side/bottom view of the print)
I'm currently printing another with these new settings (and I included the oiler):
- temp: 220C
- speed: 40mm/s
- flow: 115%
- retraction enabled, 6mm @ 25mm/s
I'll let you know what happens.