Hello,
I have been using an S5 to try and print this band saw part in ultimaker PLA without any success https://www.thingiverse.com/thing:3471256
The main body prints perfect, however when it gets to the cylinder notches on the top they appear to be overheating and just melting the layers. I have tried increasing the minimum layer time, slowing down the entire print, lowering the temp, printing multiple parts at once, a smaller nozzle, a prime tower, pausing after each layer of the cylinder, no infill- 100% infill, and I still cannot get a clean solid print. I even tried to print the cylinder separate in an attempt to glue it back in.
Any suggestions would be appreciated as I am starting to think this just isn't possible on my machine.
bandsaw.stl