stock3d

I don't have the problem now I switched back to V3.6 I am amazed that other people have not encountered the same issue cost me 1/2 roll of ABS it was definitely an issue with V4.1 happened with first and second slices that I performed the script has 10deg drops every so often till print fails.

I never ran a Temp tower it was the first print after upgrading to V4.1

Has this issue been found and fixed with V4.1 yet??

I now there is a change in the script buy why has this occurred after upgrading the V4.1 ?? this is a software glitch.

I have attached the Gcode you will notice that there is a number of M104 that progressively lower the temp I did not put this into the Gcode looks like a temp tower default. old-Vent-Sq-75mm-screw-boss.gcode

Created a Gcode using V4.1 to print ABS print temp was set to 265degC noted that throughout the print the temp setting lowed progressively to 230c which resulted in a failed print. When using V3.6 I do not have this issue is there a reason for this. Thanks