Jump to content

PrintJan

Dormant
  • Posts

    1
  • Joined

  • Last visited

PrintJan's Achievements

0

Reputation

  1. I was having this issue as well, I have successfully worked around the issue with the z-hop at extremely high speed which confuses my Creality CR-X. However, now I have again a waiting time at the end of a layer. The problem is that during the waiting time, the nozzle oozes some material, which is an obstacle later on and then the part is kicked off the bed. The part of the g-code where I expect the issue is: G1 F2400 E34.94211 G0 F4350 X162.562 Y165.762 G0 X161.547 Y166.346 G0 X152.865 Y162.822 G0 X152.19 Y161.836 G0 X150.113 Y154.224 G1 F2400 E40.94211 G1 F1500 X148.459 Y155.879 E41.00047 G0 F4350 X148.413 Y155.359 G1 F1500 X150.103 Y153.669 E41.06009 G0 F4350 X149.661 Y153.545 G1 F1500 X148.367 Y154.84 E41.10576 G0 F4350 X148.326 Y154.315 G1 F1500 X149.197 Y153.444 E41.13649 G0 F4350 X148.733 Y153.342 G1 F1500 X148.3 Y153.775 E41.15176 G1 F2400 E35.15176 ;MESH:NONMESH G0 F4350 X148.489 Y163.884 G0 X147.652 Y164.873 G0 X146.465 Y165.106 G0 X145.485 Y164.476 G0 X144.857 Y163.387 G0 X142.893 Y150.169 G0 X143.075 Y148.882 G0 X143.736 Y148.214 G0 X144.806 Y147.915 G0 X164.449 Y147.113 ;TIME_ELAPSED:269.949107 ;LAYER:2 To me it looks there are a couple of G0 F2400 E... commands which extrude but without any movement. But I'm fairly new to g-code so it might be normal?
×
×
  • Create New...