Umo_Alex

Just thinking, what about the amount of adhesive? Maybe I just used too much?

I've been able to clean things up a few times by heating it up with a hot air gun and blowing compressed air through it...

Confirmed. Prints on the back side of the plate are quite a bit harder to remove!

Member 10 Con78 posts Posted Monday at 09:52 PM · Build plate glass got etched

Spare plates seem like a good idea. Besides, each plate has two sides... 😉

I just realized what must have happened. I wanted to get a print off fast, so I dabbed it with cold water. Well, it popped right off, but that pop must've been the glass... Another lesson learnt, I suppose.

And I'm wondering why? I used 3DLac and was printing ABS with default Cura settings. (On my new 2+Connect, btw 😀) Didn't find any shivers of glass on the prints, or otherwise. So what the h*ll happened?

@Torgeir, Received the Dell adapter and tried connecting it, but there was an audible electric crackle and the LED on the adapter turned off. Assuming the connector on my board was shot I bought a new board, but the same thing happens. Just wondering if I'm connecting it in the wrong orrientation? On the UMO+ with the original brick the flat side of the connector should be downward (On the UM2+ upward). How do you connect yours?

Yeah, but I'd hoped it wouldn't have to be shipped from China, but the US. Unfortunatily it's still coming from China. (Confirmation email mentions China Post). 😔

Ordered this one: https://www.pchub.com/dell-common-item-dell-ac-adapter-20v-above-24v-123a-4p-p14v-c14-p160274 PCHub seems to be the only genuine online store that sells these (or so time will tell...). The rest are all B.S. Chinese sites!! 🙄 Grtz, Alex.

The MW power supply at findchips is the same as the one of which I've already used up two. I've been searching for that Dell brick Torgeir mentioned (or simmilar) for hours but to no avail. (btw. that allpoweradaptor.com doesn't deliver and I suspect it to be a Chinese site). So, if anyone knows where to buy the Dell brick that Torgeir has, or one that has the same specs ( output 24 VDC and 12.3 Amp) or more, please let me know! Or if you know what Dell product that adapter is for, that would make the search a lot easier.... Grtz., Alex.

Guess I'll just dump it in the bin. Spring cleaning... 😞

In my case the thing will print for about 20-30 minutes before it switches off and on again, with or wirhout heated bed.

I have the same problem with my UMO+. 1) Would TinkerMarlin work on this printer as well? 2) The GS brick doesn't seem to be available anywhere anymore. There is a GSM (medical) version with the same specs. (No idea what the difference is). Are you familiar with this bick?

If the problem only occurs with ABS and not with PLA, I'd think you have a settings problem, not a hardware problem. (Trying to think along)