dman97

I am using 3.6 now

Is it best to use the latest version of Cura, or should I keep using an older version until I notice an issue?

The ender3 has a bowden. I see "Retraction Minimum travel" which I have as .8mm. Is that the same setting

I did not see the retrack setting. I am using Cura 3.6.0. Is it in this version?

Thank you for confirming.

Would there be a problem with my prints if I have too many pieces to print out. I want to print out a cable chain for my ender 3, it is composed of 15 chain links. Could I print all 15 links at one time? I was wondering if there is too many pieces to print they could cool down too much before they get another layer of filament. Thanks.