@Burtoogle, Thank you for the link. I will take a look at those distributions Do you make them yourself? As in, do you write the code for Cura features? The setting is presently handled by multiplying the overall print speed by some decimal amount. I typically print at 40mm/s and scale the overhanging wall speed by 0.25. Overhangs are thus printed at 10mm/s. But I have experimented with higher and lower values from 5mm/s to 15mm/s with predictable results. I would prefer the feature be a function of overhang angle rather than a range of values though as different materials, temperatures, flow rates, etc. will require different reduced speeds to print the same overhang angle. I suspect an appropriate equation for such a feature would not be a simple straight line scale from 0 to 90° but rather would slow the print speed more severely at extreme angles and less severely at shallower angles. Like a scaled e^x sort of curve.