Jump to content

RaspberryPie

New member
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. My workspace has an Ultimaker S5 in addition to several other 3D printers and in-house tracking software that relies on data obtained via OctoPrint. I have attempted to connect OctoPrint to the S5 using Ethernet and following instructions for the 2 on the internet, without success. I have also found indications that Cura Connect should have an API, but I cannot find this either. Can anyone point me to instructions to (ideally) control an Ultimaker S5 via Octoprint, or to access Cura Connect's APIi? System Configuration: Ultimaker S5: hardware type: 9051-0 firmware: 5.1.8.20181207 on WiFi developer mode enabled connected to a Raspberry Pi 3B+ with an Ethernet patch (crossover cable) (after attempting with a std) Octopi (Raspbian) v. 0.16.0 Octoprint v 1.3.11 Samba version 4.5.16-Debian Cura 4.1.0 Octoprint plugin - latest Thank you for your assistance.
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!