My workspace has an Ultimaker S5 in addition to several other 3D printers and in-house tracking software that relies on data obtained via OctoPrint. I have attempted to connect OctoPrint to the S5 using Ethernet and following instructions for the 2 on the internet, without success. I have also found indications that Cura Connect should have an API, but I cannot find this either.
Can anyone point me to instructions to (ideally) control an Ultimaker S5 via Octoprint, or to access Cura Connect's APIi?
System Configuration:
Ultimaker S5:
hardware type: 9051-0
firmware: 5.1.8.20181207
on WiFi
developer mode enabled
connected to a Raspberry Pi 3B+ with an Ethernet patch (crossover cable) (after attempting with a std)
Octopi (Raspbian) v. 0.16.0
Octoprint v 1.3.11
Samba version 4.5.16-Debian
Cura 4.1.0
Octoprint plugin - latest
Thank you for your assistance.