Hi guys,
i'm using Solid Edge to design and Cura to send file to my Ender. i've printed a lot with this setup, but since week ago my printer just stops in one place for 4~7 sec producing noise like blocked stepper motor and after that time it prints normally for some time, and again stops.
First i noticed it while i changed profile in Cura from CR-10 to Ender 3. on Ender 3 profile stops and a loot of mess occured so i changed to CR-10 (on CR it printed well until this week)
I didnt modify anything in my software/hardware.
Some ideas or experiance with that error?
Thank for Your guidance