Hello,
I've just assembled my first 3D printer, an Ultimaker Original+.
I've already read a lot about fixing printing problems/improving quality but to be honest I'm a little bit lost.
What I did so far was adjusting the x and y steps after printing the XYZ cube. X and Y were a little bit too small so I adjuested the steps and know the cube is a "real" cube.
But I don't know where to start with other settings. Maybe someone can help me here to identify the problems? Or tell if it's already a good print from an UMO+.
I will be thankful for every help! 🙂
Best regards,
Daniel