UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I am just trying CURA for the first time and I am not getting smooth 1st layers and I am not sure if its an issue with settings in CURA or something to do with machine settings like Z offset or Esteps, etc.
My machine is a CR-10 - MicroSwiss All Metal Hotend with .80 nozzle.
Filament is Hatchbox PLA at 220c
I am using Generic PLA 0.8mm Nozzle - Draft Quality 0.32mm and the machine is set up using the CreawsomeMod - however, prior to the CreawsomeMod I had the same issues with the first layer.
The roughness is really at the end if each extrusion start/stop points, etc.
New to Cura - 1st Layer Problems
in Improve your 3D prints
Posted
I am just trying CURA for the first time and I am not getting smooth 1st layers and I am not sure if its an issue with settings in CURA or something to do with machine settings like Z offset or Esteps, etc.
My machine is a CR-10 - MicroSwiss All Metal Hotend with .80 nozzle.
Filament is Hatchbox PLA at 220c
I am using Generic PLA 0.8mm Nozzle - Draft Quality 0.32mm and the machine is set up using the CreawsomeMod - however, prior to the CreawsomeMod I had the same issues with the first layer.
The roughness is really at the end if each extrusion start/stop points, etc.