Jump to content
Ultimaker Community of 3D Printing Experts

litwi

New member
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. I have designed a couple of components with Rhino 6 software. I uploaded it to Cura 4.0.0 and everything works fine until I want to check the slicing. For some reason silicing messes with the layers in the following ways: The first layer of one the components is totally missing, as if it started directly in layer 2 (image "layer 1" and "layer 2"). On the same component, when the print should stop because the part is finished (around layer 74, like in image, although not exactly sure on this), it instead continues and prints horizontal layers over zones that should not h
×
×
  • Create New...