UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I am having the same problem, posted my issue, but did not receive a response. It happened when I upgraded to 4.2.1, so went back to 4.1 where there is no problem. Tried 4.3 the other day, same problem, back to 4.1. See attached pictures.
I am having a problem with printing infills. Unless Cura 4.2.1 is set to 100% infill, it will not print them, which leaves a hollow shell & no top. I have gone back to 4.1, and no problems. Is anyone else having this problem?.
Barry
I have just upgraded to 4.2.0, and I am having the same "Z Hop Speed" error. I have been trying the above solutions, but, no luck. I downloaded the "Printer Settings" from the Marketplace, but cannot see it?. I will go back to 4.1 until 4.2.0 is sorted.