Jump to content

Pygex

Dormant
  • Posts

    1
  • Joined

  • Last visited

Pygex's Achievements

0

Reputation

  1. Hi, I just bought an Ultimaker 3 and installed the newest firmware and I have the Cura 4.2 installed. The wifi setup worked and the printer is connected to wifi. However, after around 30 minutes or so, the printer cannot be contacted through wifi even though it says it has a connection to the wifi. I cannot even connect trough the browser to the printer when this happens. This is happening constantly to me. The current workaround seems to be to restart the printer when this happens but this is quite annoying especially when doing a lot of test prints for small parts and doing minor tweaking to the parts. Any help?
×
×
  • Create New...