Jump to content

gbdesai

Member
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. Thanks, that was it. I was about half an inch off on the X and a quarter inch off on the Y. All good and square now!
  2. So I just got a brand new Ultimaker S5. I started a few prints and noticed a skewing of the prints. I consequently ran a XY calibration and found the rectangles that printed actually looked like a parallelogram vs. a rectangle with 90 degree corners. Is this caused by an axis being off? If not, what else could it be. It's not an insignificant deviation, it has led to my first print (a bracket), not fitting properly.
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!