UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
oke dus nog steeds beter om de Tinkergnome te nemen?
ja ik kan niet echt vinden hoe het met de standaard firmware zit wanneer die het laatst een update heeft gehad.
Hallo,
ik vroeg me af of het nog steeds beter is om TinkerGnome firmware te installeren in de Ultimakter 2+ extended.
Of gewoon de standaard firmware van Ultimaker te gebruiken. weet niet of het nog veel verschil is of beter of slechter?
i have UM tough PLA now but it looks like it is worse now..
a lot more under extrusion
now working on replacing the nozzel completly maybe it helps.
it is very frustrating 😞
dank je wel en zal de lijst gaan zoeken.
het is nog steeds niet verholpen nadat ik zoveel geprobeerd heb.
en zoveel uur heeft de printer nog niet gedraaid.
ja temp en snelheid is lastig. hoe weet je welke temp welke snelheid het beste is?
with normal PLA i dont had any problems.
but i want to use PLA+ because it is stronger.
I hoped that someone could help me and that it is just a setting or something because PLA+ is a bit different.
Hello
I have a problem with printing with PLA+
i have a lot of under extrusion and it looks like that mostly/all happens when retraction is used.
and with a lot of retraction hapening a lot of under extrusion
i tried a lot of solutions i found on the net but nothing helped so far.
you can see my problem on the pictures.
hope someone can help im desperate
Printer: ultimaker2 ext+ With TinkerGnome firmware.
Filament: eSun Pla+ Black 2.85mm
Hallo Allemaal.
ik zit al 2 weken met een probleem met printen van PLA+.
Ik heb erg veel last van under extrusion in mijn prints. het lijkt wel under extrusion pas gebeurd bij het terug trekken van het filament tijdens de prints.
dus hij print de bodem wel goed maar zodra die gaat beginnen met terug trekken van het filament om naar een andere plek te gaan dat hij daarna under extrusion krijgt.
niet altijd want soms gaat het antallen lagen wel weer goed.
Het is ook zo hoe meer die moet verplaatsen en dus terug trekken hoe meer het voorkomt.
ik heb foto's bij gevoegd om een beeld te geven.
Hopelijk heeft iemand van jullie een idee. ben er nu al zo lang mee bezig
heb al veel oplossingen die ik op internet gevonden heb geprobeerd maar krijg het maar niet juist.
heb een ultimaker2 ext+ met TinkerGnome firmware erop.
ik gebruik eSun Pla+ Zwart 2.85mm