Hi,
thanks for taking the time to answer! What you say sounds most logical and I went ahead and got 4.1 back so I could go on printing the way I am used to. I am not against having the new layer hights thing is just that the highest layer hight that was offered to me was .32 and that is almost 25% slower than the 0.4 that I used to use.
If anyone could show me how to make a new profile that allows for 0.4 it would be highly appreciated. I often do mockup prints with 10% infill and 0.4 layer hight to see how things will look before I go for the good quality so this layer hight is really important to me.