Jump to content

LukasAV

Member
  • Content Count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. It seems like a previous part of the model was not correctly attached which broke all steps afterwards. See FreeCAD forum Thanks for all your help!
  2. Thank you very much for your help. I am sorry I did not state clearly enough I also created the model in FreeCAD, thats why I attached my FreeCAD project file (had to zip it so I could upload it). I viewed the model in x-ray mode and the flat peaks of the thread are indeed red, so I suppose this is an error from FreeCAD when creating or exporting the thread.
  3. Hi, I created a model with an inner thread using FreeCAD, exported as an .stl. The thread is displayed correctly in FreeCAD and Blender and also in Cura. However, after slicing, Cura wants to print the section with inner thread as a complete block. I tried different settings, turning support on and off, but always got the same result. Using Cura 4.2.1 on Linux Mint 18.1 Cinnamon 64-bit. Thanks for any help. test2.stl bottom-demo.FCStd.zip test2.3mf
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!