Jump to content

Bearthunder

Member
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. That actually looks quite interesting! Thank you. 🙂 Would you also happen to have some advice on what firmware (running on an Arduino board with Ramps 1.4) would be easiest for me as a total noob would be easier to tweak to for me?
  2. I've rebuilt a 3D printer to work as a macro focus rail for photographing, and I'm testing Cura as a software to control the stepper motors. Everything works great, but I have a question. In the Monitor -> Printer control, where can I set the jog distances to be used? I was looking for some sort of ini of config file, but can't anything. The minimum of 0.1 is actually too much in my case as I need to be able to do steps down to 5 microns or less. :-P Are the settings adjustable without too much problems, or are they hard coded into the software?
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!