Hi experts! I sure could use a hand here please. I was trying to tune out some very repeatable zits, only in the end did I look at the tool path preview. Low and behold there is indeed tiny yellow dot outside the wall exactly where my zits are! The move itself is a bit weird - why not travel directly to destination ? I can also observe the zit being extruded using http://gcode.ws/
In the attached, watch layer 14. Happens on loads of layers, but not every layer, e.g layer 17.
I'm out of my depth here! Kindly advise.
Thanks
Tim
retraction test - cylinder.3mf retraction test - cylinder (1).stl