chas2706

@tanker2157 Hi, yes if you go into machine settings and start.g in Cura and edit out the g.code after the homing cycle (G28). Do this by putting a semicolon before the command. If you not sure, upload a screenshot of your start.g.

I found what the problem is. It is directly related to the creawsome settings that are applied in the cura start.g file. The max feedrate settings are M203 X500 Y500 Z10 E50. I am running my ender 3 pro with a duetwifi board where the M203 command is set at X900 Y900 Z600 E6000 so I commented out the M203 in cura start.g (and the rest of the speed settings) and now my printer is back up to speed. So I apologise for blaming cura, it is the ridiculously slow speed settings in creawsome. Like I pointed out in my first post a 18 minute print was taking well over 2 hours.

@DidierKlein Ok thanks for that. I have done that, grabbed the machine and print profiles for ender 3 but something in this is making my printer extremely slow and it pauses after every move and so is unusable.

Also, this version (4.3) says comes complete with the creawsome mod built in. That's all very nice but no instructions whatsoever on how to enable or use it!

Just upgraded from cura 4.1 to cura 4.3. Imported profiles and as usual everything gone pear shaped. Sliced and uploaded a model (estimated print time 18 minutes) to my ender 3 pro and 2 hours later it is only 64% complete. Printer extremely slow. Was ok on 4.1. Cheers again ultimaker!