Hello there,
Because heating up the bed takes a while, I'd like to accomplish the following:
(Non-blocking) heat up bed to bed temp
(Non-blocking) heat up T0...Tn to standby temp(s)
(Blocking) Heat up bed to bed temp
(Blocking) Heat up T0 to print temp
...
I have a rough sense of how to manually change the start gcode to do it, but I wanted to check whether it's already possible some other way (e.g. via the UI) or otherwise what the optimal gcode sequence is—for instance, I'm not sure how M105 factors into things.
I'm also wondering whether there'd be any unintended side-effects or if it's known to be a bad idea, period. (Note that in my case the printer doesn't support auto-leveling, which could presumably be affected by changing the order/asynchrony of temperature changes; and at any rate, I don't see any G29s emitted anywhere.)
Thank you!