Jump to content

jeremyfiller1986

Dormant
  • Posts

    1
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

jeremyfiller1986's Achievements

3

Reputation

  1. Well im a few years late but I know this is the solution to the original problem and hope it helps someone. Once Cura starts up fallow the below tabs is that doesn't make sense I attached a photo too. ONCE YOUR IN CURA Preferences > Configure Cura > Settings > Build Plate Adhesion > Extruder Prime X Position OR Extruder Prime Y Position, you can also turn the blob at the end off or on as well in that same area. 😃
×
×
  • Create New...