Jump to content

vagulus

Member
  • Posts

    5
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Other 3D printer

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

vagulus's Achievements

0

Reputation

  1. I too am looking for a Raise3D Pro2 Plus profile for Cura. I have had the same experience as Phildon https://community.ultimaker.com/profile/388280-phildon/ in that the printer heats up an nothing happens any more. Has anyone solved the problem?
  2. Ah Ha! Thanks BTW: I am printing on BuildTak and I find that support doesn't stick well to the surface. So, I create a raft and use 1.5 mm of support under the model without any high density layer on top. The model builds on the support just fine but I can then remove the model from the support without a struggle. Do you have a better method?
  3. Are we sure we are talking about the same thing? I am not talking about a (e.g. 0.15 mm) 'gap' between the raft and the model which is supposed to stop the model sticking to the raft like a limpet on a rock. I am talking about elevating the model 1.5 mm above the raft and filling that space with support material. Is that what they call 'Raft Air Gap' ? There is a setting available for offset in Z axis but when you change it it immediately reverts to zero. I can't set it to 1.5 and have the model jump up!
  4. Are we sure we are talking about the same thing? I am not talking about a (e.g. 0.15 mm) 'gap' between the raft and the model which is supposed to stop the model sticking to the raft like a limpet on a rock. I am talking about elevating the model 1.5 mm above the raft and filling that space with support material. Is that what they call 'Raft Air Gap' ?
  5. I like to have 1.5 mm of support below the bottom surface of my models. It makes it easier to remove the model from the support mat. How do I set Cura 4.3.0 to give me that gap and the support in it?
×
×
  • Create New...