PieterLemmens

Hi @Smithy, I'm looking for some additional information on the webcam. Is there a brief manual for that? Can i plug in a usb webcam to the USB interface in the S5? Thanks Pieter. Ps: the disabling of the leveling works fine.

Similar issue here. model S5, updated firmware and i have reset factory settings. But i noticed: the colder it gets outside... the more often the problem... I had a small heater near the printer ( about 0.5m away). I think it might be causig an interference. The warm air raising next to the printer may cause some ESD issues??? It's a large volume of moving air. @dmanthei, you also have an air unit nearby? You might want to move that one and test. Anyway. Just sharing my thoughts here. Rgds P

I'm having the same issue... Is there any update on this matter?

Hi there, I have the same question, especially the ABS+ from ICE. I've printed the PLA 2 years ago. That worked out pretty nice. thanks Pieter