Jump to content

liga

New member
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. good day Today I encountered such a problem External Wall Print Speed whichever value is specified in the speed settings cura swaps it down for example I set the print speed of the outer wall 30 mm / s in gcode I see F = 944.6 and it should be 1800 if I put 60 mm / s the value will not change but if I increase the wall from 20mm to 40 mm the speed will rise from 944.6 to 2188.9 mm / m Why does the Sura automatically reduce the speed of the outer wall depending on the length of the segment? Is it possible to disable this feature? Below is the GCODE for a square with a wall of 1 perimeter and a print speed of 60 mm / s ;LAYER:2 ;TYPE:WALL-OUTER ;MESH:20mmTestCube_repaired.stl G1 F944.6 X-9.8 Y-9.8 E68.75189 G1 X9.8 Y-9.8 E69.40379 G1 X9.8 Y9.8 E70.05569 G1 X-9.8 Y9.8 E70.70759 G0 F3600 X-9.8 Y9.6 G0 X-9.4 Y9.4 ;MESH:NONMESH G0 F600 X-9.4 Y9.4 Z0.9 G0 F3600 X-9.8 Y9.8 ;TIME_ELAPSED:33.907640
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!