good day
Today I encountered such a problem
External Wall Print Speed
whichever value is specified in the speed settings
cura swaps it down
for example I set the print speed of the outer wall 30 mm / s in gcode I see F = 944.6 and it should be 1800
if I put 60 mm / s the value will not change
but if I increase the wall from 20mm to 40 mm
the speed will rise from 944.6 to 2188.9 mm / m
Why does the Sura automatically reduce the speed of the outer wall depending on the length of the segment?
Is it possible to disable this feature?
Below is the GCODE for a square with a wall of 1 perimeter and a print speed of 60 mm / s
;LAYER:2
;TYPE:WALL-OUTER
;MESH:20mmTestCube_repaired.stl
G1 F944.6 X-9.8 Y-9.8 E68.75189
G1 X9.8 Y-9.8 E69.40379
G1 X9.8 Y9.8 E70.05569
G1 X-9.8 Y9.8 E70.70759
G0 F3600 X-9.8 Y9.6
G0 X-9.4 Y9.4
;MESH:NONMESH
G0 F600 X-9.4 Y9.4 Z0.9
G0 F3600 X-9.8 Y9.8
;TIME_ELAPSED:33.907640