wal_ter

Hi everyone, I did not finde a good title. Any Ideas? I want to print the following structure with Cura 4.4. The structure is almost cylindrical. It is slightly conical with a 0,5 degree draft angle. The diameter at the bottom of the structure is 3mm. It is part of a case where a screw will be screwed in. The next image shows a cross section of the lower area. I print with a 0.2mm nozzle. The yellow print path lead to problems. It is not circular like the green and red paths. Does anyone know how to prevent the yellow print paths? I would like to have circular print paths at the whole cross section.