Jump to content
Ultimaker Community of 3D Printing Experts

Dseven

Member
  • Posts

    2
  • Joined

  • Last visited

Dseven's Achievements

0

Reputation

  1. Hmm. I did notice that it was not flat on the bottom .. but it was close enough that the skirt became part of the object. Maybe the skirt should consider any overhanging areas that are within a certain elevation of the base? I accept that it's a buggy model, though - thanks!
  2. So I used Cura 4.4.0 to slice https://www.thingiverse.com/thing:3057351 for my Ender-3 Pro (0.15mm, 10% infill, supports on), and was surprised when the object was printed over the skirt on one side! Not a big deal in this case - I snipped it off, and it's on the under-side, so not visible... but this seems like a bug? The skirt should go around the widest points on all sides of the object... ? (yeah, I have some calibration stuff to get dialed in too, but I don't think this is a calibration issue)
×
×
  • Create New...