So i need to print a couple of lines in a structure like this:
The single lines should be a different .stl file I have been told. And I already have a geometry.
The problem comes when loading into Cura. Cura either says the file is too small. As i am printing the vertical lines in surface mode to make sure there is only one pass.
This problem i have sort of fixed by making these bigger geometries. However now everytime cura tries to slice this a lot of beams fall away. This happens very irrigularly.
I hope some of you guys can help.
These are the models if i can load them into cura. This still wont be seen in the slicing.