Jump to content

Capbat

Member
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Hi Falsf Thanks for your answer. I am including the .stl file that I used. In the original file as you will see the statue is on it's side and it is only 1.215mm tall!. So what I did is to move the statue so that it would be vertical with a lot less support than on it's side. And enlarged it so that it would be 50mm tall. (Z axis.). And that's what you see in the picture. Thanks again waiting for your answer. Ing moai-head-on-easter-island-1.stl
  2. Hi.I am with Cura 4.4.0Octoprint 1.3.12Octpi 0.16.0Chrome BrowserI am trying to print a Bust of an Easter Island Statue, and I generate support everywhere and Cura comes up with support that starts in mid-air. I tried playing around with support xy and z distances to no avail. Thanks for your comments and/or suggestions. Ing.
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!