Jump to content

Viggoman

New member
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. I'm experiencing a bed temp error message after e few minutes of printing. It seems to happen at more or less the same spot every time. Recycling the power clears the error, but it repeats after a few minutes. I have had a bed temp issue a few month back and followed the trouble shooting instructions, even replaced the main board. But it wasn't until I checked the wire connector at the bed it got solved. I have tried this out again to no avail. Any tips tracing the culprit of this? Thanks
×
×
  • Create New...