Jump to content
Ultimaker Community of 3D Printing Experts


New member
  • Content Count

  • Joined

  • Last visited

Posts posted by Viggoman

  1. I'm experiencing  a bed temp error message after e few minutes of printing. It seems to happen at more or less the same spot every time.


    Recycling the power clears the error, but it repeats after a few minutes.


    I have had a bed temp issue a few month back and followed the trouble shooting instructions, even replaced the main board. But it wasn't until I checked the wire connector at the bed it got solved.


    I have tried this out again to no avail. 


    Any tips tracing the culprit of this?



  • Create New...