quad121

Many thanks for your reply Carla I will try your suggestions and see how it goes.

Hi, sorry. the material is PLA Matte from Filamentive. the printer is a Creality Ender 5 Pro with a SKR 1.4 turbo motherboard printing temp is 210 at 60. the hotend is a E3D V6 using standard brass 0.4mm nozzle retraction is at 3.8 with speed set at 60

Can someone advise on a possible ‘fix’ for these printing faults on this ‘Benchy’ please ? I’ve tried different settings but can’t seem to sort this out. On the side of the cabin.

Good afternoon to you all. I wonder if anyone can help me with this predicament? I’ve installed the BLTouch and the modified Marlin 2.0.1 firmware. On running through the BLTouch setup the nozzle goes to the centre correctly and does 2 levelling checks then stops around 10mm off the surface I go to the z axis and move it to 0.00. This then gives me around a 5mm gap. I then go to the z offset to adjust to the final 0.2mm setting but on turning this the z axis doesn’t move? Even after dialling in 8mm on the display? Can anyone help? Please

I wonder if anyone knows if there is a g code line which can be added to the ‘start’ g code section to stop the ‘thing’ cooling fan whilst preheating? i don’t know if you can do this here or in the Firmware settings.

I have just bought a 3D Printer from Lidl the Balco 3D Touch. I have been having problems with the prints not printing centrally, they seem to either print on the edge of the plate or run out off the edge!as I’ve never used a 3D printer before, I’m having trouble setting up for the printer to do this. I’ve been using Ultima Cura, I’ve then ‘sliced’ the object then saved it as a ‘gcode’ file saved it to a memory card. Here is a screenshot of the settings page, I would really appreciate any help in this matter. Thank you.