Khallisa

Thank for the reply and the help, It seems the temperature might be the culprit. Printer has a diy enclosure that might be getting in the way of the printer cooling. I'm running a set of long prints without enclosure to see if it repeats. Filament had no grinding but it might have been a safety stop from the heat. Thanks again for the reply that gives me somewhere to start. Cheers

Hi There, I'm having an issue printing a model , its comes out with the top half of the model completely offset from the lower area. Not sure if related but for the last couple of prints, The printer stopped at 80-90% without message of error or completion. Printer Anycubic mega S filament : esun abs silver. Slicer cura 4.4.0 Any help or suggestions would be appreciated. Cheers