AyatsOT

Appreciate your experience, thanks.

Sounds good to protect the UM glass with UM adhesion sheets, I will try it. This issue only appears with CPE+, in my opinion, because high temperature in the plate, 100ºC. With tough PLA it's OK.

I smeared without dampened cloth. I attach a photo of the glass. The glass is the same. It's the second glass with these issues so I'm afraid to use the third. I don't use any tool to remove it because when its cold the part pull out itself. In hot it's impossible to remove it.

Good morning, Printing with UHU stic on the glass and without any plate adhesion type, the glass became damaged again. Small glass parts appears glued in the part, see photo attached. Is it normal? this no have sense. On this way the glass must be replaced every week.

Ok thanks, I will try it with UHU stic delivered in Ultimaker S5 accessory box. Do you recomend to use raft or brim? I would prefer brim because it's eassier to remove it than raft. In other words the raft became welded on the part, may be I have some parameters worng. On the other hand I use raft to get air between the glass and the part to avoid any glass damage, but some times doesn't work and the resolt is the raft welded in the part

Good morning, I have huge issues printing with CPE+. It brakes the glass. The temperature plate is 110ºC. I remove the part in cold. Printing with brim the glass brakes, printing with raft too but it seems better. Has someone experience in that issue? Thanks