Hi guys, I think you have the best slicer software, I've been using Cura since version 3, in fact I didn't want to swap to Cura 4, then I saw it was faster without slicing anytime you change settings, but since Cura 4.2 it is not supporting Klipper, I'm using Klipper in both of my printers Ender 3 and Tevo Tarantula, but anytime I install Cura 4.2 or 4.4 or any version after 4.1 it makes a lot of changes and my custom profiles are removed for Ender 3 and it makes me work with the default profile, even when I create a new custom profile, 1st I cannot name it as the old profile, in this case I had to rename Klipper 2019 to Klipper 2019. and even when I create the new profile it doesn't work with the settings for Klipper, it is a lot slower, even in my Tevo Tarantula where it preserve the old profiles it works a lot slower, please take a look to the images, until now I have to use only Cura 4.1 because none of the newer versions work with Klipper firmware besides they remove older custom profiles for Ender 3