UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Well here they are, printed out of TPLA. Turned out pretty good. Haven’t printed with them yet, but did check the temp with a heat gun near that area while the printer was running and it never got above about 70-80F so I think the TPLA will be fine. They fit nicely too, popped right in. I’ve got some PC coming for Christmas so I may do a few out of that too. Thanks again for the STL! Cheers!