Jump to content

Dash777

Dormant
  • Posts

    2
  • Joined

  • Last visited

Dash777's Achievements

0

Reputation

  1. Is someone here able to implement a 'Maximum unsupported Height For Bridging'? I forget ask this with my previous post. Thanks again.
  2. So Im currently using Cura 4.0 and trying to utalise bridge settings and supports on the same model. I have found that this is possible to do but it only applies the Bridge Skin settings. This is done by increasing the Bridge skin threshold to 100%. I would like to be able to use the bridge settings for the walls also but cura doest see these as bridges. So my initial thoughts for a fix would be to have a user defined option to set maximum unsupported height for bridging. So for an example. When using a support top distance of 0.2mm, and a maximum unsupported height for bridging of 0.2mm also. Cura would now apply all bridge settings regardless of supports or not. This I think is beneficial for filaments like ABS and PETG that tend to fuse to the supports below them. It would allow for extra part cooling and flow reduction and speed which I think is paramount for these filaments. Thanks
×
×
  • Create New...